UVT ultra-precision ball spline with 2 grooves. Spline nut: standard type, extended type. Shaft rod: 3, 4, 5, 6, 8, 10, 12, 15, 20, 25, 30, 40, 50mm, Shaft rod support mounting position processing.

UVTF flange type ball spline with 4-point contact design realizes: compact but high rigidity, high precision positioning, and smooth movement with less friction. Nuts are available: standard type, extended type, and the shaft supports customization as required.

ULT straight type 4-slot 8-point ball spline with high precision, high wear resistance and long service life. Support non-standard customization.

ULF round flange type, 4 rows of grooves 8 points type high precision positioning method. Shaft rods are available: 6, 8, 10, 13, 16, 20, 25, 30, 40, 50mm, and shaft ends can be machined.

Adopting two rows of steel ball circulation structure, through the precision groove grinding to realize high-precision transmission. All series of specifications in stock, the ball and raceway by vacuum hardening treatment, hardness up to HRC60 ± 2, load capacity increased by 30%, can be a direct replacement of the same type of TBI products, shorten the maintenance cycle of the equipment.

Adopting two rows of steel ball circulation structure, through the precision groove grinding to realize high-precision transmission. All series of specifications in stock, the ball and raceway by vacuum hardening treatment, hardness up to HRC60 ± 2, load capacity increased by 30%, can be a direct replacement of the same type of TBI products, shorten the maintenance cycle of the equipment.